This electric powered, radio controlled, ready-to-fly. Hobbico Electristar Select Trainer RC Airplane is for Beginning Pilots wanting the simplicity of electric power with the feel of a traditional .40 size glow trainer.
Features
* Construction: Balsa and ply with bolt-on tail assembly for easy removal if required
* Wings: Two-piece with aluminum wing joiner tube, installs with rubber bands
* Aileron Control: Single servo
* Covering: Top Flite MonoKote, see COMMENTS
* Motor: Electristar C-42 Brushless (HCAG3129)
* Radio: Futaba 4EXA 4-channel FM computer system with trainer system 7ch receiver, NT8F6008 (FUTM1440) TX battery, NR-4QB receiver battery FUTM1295, 110V wall charger for TX and RX packs
* Servos: Three Futaba S3003 standard servos (FUTM0031) one each for elevator, rudder and ailerons
* Speed Control: ElectriFly SS-45D for brushless motors (GPMM1841) with Deans Ultra male battery connectors
* **NOTE: If using a battery other than the one recommended, the Deans 2-pin Female Ultra connector (WSDM1303) may be required to be installed on the battery
* Propeller: 11x7 plastic, black in color
* Spinner: Plastic 2.25" (57mm) diameter, white in color
* Battery Compartment: Accessible on bottom on fuselage, battery door held on with nylon latches
* Landing Gear: Prebent 0.16" (4mm) diameter wire for main and nose gear
* Wheels: Three 2.75" (70mm) foam
* Building Time; Ready to fly in approximately 1 hour